ZoneDeckfor Russound RNET systems
Setup

Set up your ZoneDeck

Four steps, about five minutes. Nothing to install.

STEP 1

Plug it in

Cable into your Russound controller's RS-232 port. Then power.

RUSSOUND RS-232 ZoneDeck POWER
STEP 2

Join the ZoneDeck Wi-Fi

On your phone, go to Settings › Wi-Fi › ZoneDeck-XXXX. No password needed. The setup page opens by itself.

Wi-Fi
Networks
ZoneDeck-7131
Home Wi-Fi
Neighbor 5G
STEP 3

Pick your home Wi-Fi

Enter its password and tap Connect. Then find your controllers and name your rooms, right there.

Connect your hub
Home Wi-Fi
Neighbor 5G
Password
Connect
STEP 4

Open ZoneDeck

Tap Finish, and your phone goes back to your home Wi-Fi. Open zonedeck.local in Safari and add it to your home screen.

Open my hub →
zonedeck.local
ZoneDeck
KitchenON
Living Room
PatioON
Bedroom

Need help?

I don't see ZoneDeck in my Wi-Fi list

It's offered for 30 minutes after plugging in, until the hub is set up. Unplug it for 10 seconds, plug it back in and look again after a minute.

The setup page didn't open

While on the ZoneDeck Wi-Fi, open Safari and go to 10.42.0.1.

zonedeck.local won't open

Check that your phone is back on your home Wi-Fi and type http://zonedeck.local. Some older Android phones can't open .local addresses: find "zonedeck" in your router's device list and use the address it shows.

The hub couldn't join my Wi-Fi

The ZoneDeck Wi-Fi comes back within a minute with the reason, usually a mistyped password. Join it again and retry.

I changed my Wi-Fi

If the hub is still online: ⚙ Settings › Change Wi-Fi network. If not, unplug it for 10 seconds and plug it back in, then start from step 2.

I forgot the admin PIN

Unplug the hub for 10 seconds, plug it back in, and within 10 minutes tap Reset PIN on the PIN page.

Start over

⚙ Settings › Support › Factory reset. Save a backup first if you might want your names back.